COLD START Instructions

1. Mount good tape on drive 0
   Mount scratch RK or RP on drive 0
2. Key the following at location 100000
	012700
	172526
	010040
	012740
	060003
	000777
3. 100000 in switches; Load Address; Start
   The tape should move and the CPU loop
4. Halt the CPU; 0 in switches; Load Address; Start
   The console should type '='
5. Put 2 in the switches
6. Perform the following dialog
   Input is underlined
   < indicates CR or LF either.

	=MCOPY<______
	'p' for rp; 'k' for rk<
	K_< 		(or P_ for rp)
	disk offset<
	0<__
	tape offset<
	76<___
	count<
	4000<_____		(wait for tape to read and rewind)
	=UBOOT<______
	K_<		(or P_ for rp)
	USR/SYS/UNIX<_____________
	MEM = xxx<	(where xxx is available core in .1K)
	<
	:LOGIN: ROOT<_____
	#
At this point, UNIX is up and running.
One of the first commands should be
	# CHECK /DEV/DEV0<________________
To check the consistancy of the disk.
Next on the list is to edit the password file
to put in new users. (The only valid IDs
are ROOT and BIN both without passwords.)
Put password on ROOT and make new directories.
The disk is very full of source that
is meant just for the curuous.
It may be removed or dumped off line
with TP before being removed.

Be sure to type SYNC before shutting
down UNIX. To reboot UNIX warm,
a) Perform all of above except
   the MCOPY dialog.
b) The DEC RP/RK ROM will get
   you to step 6 above.
c) If core is still intact, restart at 0.